1 / 4
Jonsbo N5 Hard Drives Bay Shroud for 2x 140mm Fans — image 1
1 / 4

Jonsbo N5 Hard Drives Bay Shroud for 2x 140mm Fans

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Component to mount 2x 140mm fans to the front part of the Jonsbo N5 case.

Rating
0 / 5
Likes
4
Downloads
109
Makes
0
Views
1,130
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Standard Digital File License

This is a two part component.

It is a 2x 140mm shroud for the Jonsbo N5 to be mounted in front of the drive bay. The original wooden slotted cover will mount on the front of this component.

I designed this component to fit my very specific print situation. I printed it in two parts diagonally on my H2D. It may not fit your printer. IMHO if you have to split this part to print, it might not be worth your time, there are other great options for the Jonsbo N5 case available.

Materials Needed:

  • 4x M3 Heat Set Inserts
  • 2x M3x15mm Bolts
  • 2x M3x20mm Bolts
  • 10x 8mm x 2mm round neodymium magnets
  • 2x 140mm fans

My Print Settings: (YMMV)

  • H2D diagonally with one print head.
  • Low supports for the lip edge
  • PETG 0.4mm nozzle, 0.2 layers, 15% infill, 4 walls. (I am a fiend for more walls.)

Notes:

  • I used 2x Noctua NF-A14 industrialPPC-2000 3-pin (non-PWM) fans because:
    • the Noctua industrial line has a high static pressure rating (4.18 mm H2O!) and the narrow gaps between the drives on the Jonsbo N5 makes me think I need it. 
    • 3-pin because no point in using spending more money on a 4-pin because the drives in this build are probably going to be the hottest thing. And also because I used the 3-pin fan pinouts on the back of the back plane. For the rear fans, I routed to my motherboard to use 4-pin PWM.
  • I gave the fan slots more clearance because Noctua fans come with the rubber dampeners that I want to fit in there without disfiguring them.
  • Take care when installing the fan crews, the ears to mount the fans are only 2mm, if you over tighten, they will break.
  • Each inset hole for the 8mm x 2mm magnet will be a loose fit, use gorilla glue or other plastic adhesive. The back magnets, what I did was glue one down, and just magnetically attach 3 more so that it reaches the metal on the case mount for the case to “snap” on. It seemed easier than extruding and requiring more supports.

Tags