Original Prusa XL Enclosure Door Seal
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Prusa XL Enclosure draft fix: print mods + weather strip seal door gap to reduce warping from fan airflow!
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 47
- Makes
- 0
- Views
- 620
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Original Prusa XL Enclosure is far from airtight. The largest gap—between the door and the frame—lets in drafts, especially when the enclosure's ventilation fan is running. Since the print bed sits right at door level, this airflow can cause serious warping on the initial layers.
This print mod, combined with 5 mm brush weather stripping, effectively seals that gap and stabilizes the internal environment. I applied the same weather strip along the curtain (aligned with the door) and on the mod edge to close it off completely. There is a hook in the back that hooks onto the door frame to keep it in place as the brush forms a tight seal. The magnet holds it all in place!
Each mod also uses three neodymium magnets (30×10×3 mm) for strong attachment. A print pause is added at layer 60 to insert the magnets before the top layers seal them in.
Materials:
5 mm brush weather stripping
https://amzn.to/3IEu7vS
Neodymium magnets – 30×10×3 mm
https://amzn.to/4f15plm
Affiliate links above. I may earn a small commission at no extra cost to you.
If you enjoy it, please like and upload a picture/print. I would really appreciate it!
