1 / 8
NVR box for board 9CH XM8536E
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
case for network video recorder from aliexpress
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 93
- Makes
- 0
- Views
- 454
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
The case is made for a cheap popular video surveillance board from Aliexpress (46х118mm 9CH NVR). To store the recording, I use an old solid-state hard drive without a case 65x42 mm. This model does not use screws.
Assembly sequence:
- insert the SSD drive into the case in the lower groove, power connectors on the left, SATA on the right (carefully, the gaps are minimal).
- connect the power and data cables to the NVR board
- insert the NVR board into the case
- carefully connect the cables to the SSD
- close the lid by inserting the lower groove and closing the latch with a little force.
Printing
I used PETG material. I used the usual settings for this material. Nozzle 0.4 mm. No supports are required. Print with the ventilation slots down. When printing the lid, for the strength of the latches, make the minimum blowing in the slicer settings.