Lid with brush holder for cleaning with Vallejo Brush Cleaner and Brush Restorer bottles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a lid with screw in holder for soaking the paint brush in the Vallejo 85 ml / 2.87 fl oz bottles.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 165
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Miniature Gaming Accessories
- License
- Creative Commons — Attribution — Noncommercial
It's a lid with screw in holder for soaking the paint brush in the vallejo 85 ml / 2.87 fl oz bottles.
It's 3 parts.
A lid to screw on to the Vallejo Brush Cleaner og Brush Restorer bottels (85 ml / 2.87 fl oz).
A brush holder that screws into the lid, with a tread on the side to lock the brush in place.
Screw to lock the brush in place.
At the moment it supports brushes up to ø 8.75-9 mm handles, plan to add a holder that support up to ø 14 mm, that should cover most brushes for model painting.




Had to do some tweaks to the models holder rod tread part had to be made wider 16 to 17 mm, to support bigger brushes when I make the ø 14 mm holder rod.
The bigger holder rod prints fint, it had a big tighter fit though. It holds a lot of big brushes if dry brushes are needed most of mine fit in, I would not recommend putting the brushhead in first if the fit is too tight, try backwards then if posible.








I printet in pla, 0.4 nozzel 30 % infil supports organic layer height 0.2 mm. There was a little bit to clean up but nothing major, for me the lids tended to string a little at the end near the top.



Do be carefull there is no need to tighten to much, ít will only leave a mark on the handle, a little goes a long way.
Im unsure if soaking the brush in the Brush Cleaner is a good idear, but soaking in the Brush Restorer is recomended to do in some cases on the bottle.