GoPro Dual Battery Charger Box

-+- What is it? -+-

This is a case that holds the following items:

• Dual battery charger and batteries
• Two micro-SD cards
• One SD-card
• Gopro-screw
• GoPro-she mount

A nice feature is the possibility to charge the batteries while the dual charger is in the case. You can see into the box in order to see the battery level indicator on the dual charger.
The SD card holders are made to keep them in place. If the cards fall out, the g-forces should be your main concern…

-+- You will need -+-

3D-printed parts
1 x case
1 x lid
1 x latch

Hardware
2 x M3 x 25 mm screw
2 x M3 x 20 mm screw

-+- How to print -+-

• 10% infill
• Layer height/quality: 0.3 mm (0.4 mm nozzle)
• Support should not be needed.
• Brim should not be needed.
• Orient both parts as a bowl on the print bed.

+ How to print with fuzzy skin +

Only the outside of the part can have fuzzy skin. A separate setting without fuzzy skin must be applied on the inside of the case and lid to print the part.

Step 1:

Set the standard fuzzy skin settings like you normally would. I recommend Thickness = 0.2 and Density = 1.25.

Step 2:

Place the “meshFix” in the same position as the case or lid.
Rescale the "meshFix" to approximately 97% size in x and y.

Step 3:

Select the "meshFix"-object. 

3.1 Select “per model settings.”
3.2 Select “Modify settings for overlaps”
3.3 Select “Cutting mesh”
3.4 Open “Select settings.”
3.5 Select “Fyzzy skin”-setting and press “close”
3.6 Deselect ”Fuzzy skin"

-+- Support -+-

If you have any questions, feel free to contact me. I am no saint (probably) but I will do my best to help.

-+- ❤ Credits ❤ -+-

latch design from “GoPro 9/10/11/12 - Rugged Case 2 Battery Box” made by the fantastic Spock.
SD-card-holder design from "Modular GoPro Hard Shell Case Organizer" made by the prestigious Neon Gray.