1 / 2
CineTape horn backing w/ 1/4"-20
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Added 1/4"-20 w/ arri locating pin holes for the CineTape horn
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 41
- Makes
- 0
- Views
- 201
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
Modernizing the Cinetape backing. Can be printed at an angle or with interior side down, both needs supports.
Tolerances are fairly tight, so best to calibrate your filament. Gasket is meant to be printed in TPU. Everything else preferably in ABS/ASA or something that can withstand higher temps than regular PLA.
Reuse original screws but be careful not to over tighten as it's just screwing into plastic.
For the ¼"-20 heat insert, you'll need the E-Z Lok E-Z Sonic TH-420-SV.