1 / 2
Filament cutter 60° easy to empty cutter box (with backstop) — image 1
1 / 2

Filament cutter 60° easy to empty cutter box (with backstop)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

gotta catch 'em all.

Rating
4.767 / 5
Likes
110
Downloads
595
Makes
29
Views
3,016
Reviews
30

Updated at source:

Model information

Category
Accessories
License
GNU General Public License v2.0

One to rule them all.

I simply liked the idea of:

  • Filament cutter tool (thanks Pomi)
  • Sharper point cutter tool (60°, thanks kk)
  • That it could catch the leftovers (thanks Wapameepto)
  • But without wasting too much (thanks -IIl)
  • And it had to be easy to remove when necessary (thanks fuchsr)

 

Assembly instructions (copied from Pomi's Filament Cutter):

  1. Print both parts (top and bottom)
  2. Take one piece of snap-off blade and put it into upper part. Use some pliers to avoid an injury. There is a small mark near blade pocket which shows you where the tip of the blade should be. Additionally you can use super glue to fix it in position.
  3. Put both screws into the holes.
  4. Put ball pen springs into the holes.
  5. Place the upper part on the main body and press it fully.
  6. Tighten the screws. Screw head should be about 1,5 mm inside head holes. If you will tight them too much it will destroy plate at the upper part.
  7. Release upper part and check if blade is not visible inside the filament hole. If yes loose the screws little bit.
  8. I recommend to put some lubricant inside to keep the mechanism running smoothly.

 

Long live the remixes.

Tags