1 / 3
Headmame V2 M3 clamps
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replace M2 self tapping screws with M3x10 BHCS+heatsets
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 25
- Makes
- 2
- Views
- 110
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM:
- 4 M3x10 BHCS
- 4 M3x3x5 heatsets (shorter than Voron spec) - I used these: https://www.amazon.com/dp/B0C4GDBXML
Print as per normal headmame V2 specs, including painted supports on the covers. Install 2 M3 heatsets into covers with a soldering iron/heat insert press. Affix the same way to the spring but this time you will use an M3x10 BHCS instead of an M2x10 self-tapping screw. It's much easier to get the alignment in place, and I did not even need to modify the included leather headband.