Noodle / Pasta rack for drying fresh pasta
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This multipart assembly uses chopsticks as bars for fresh pasta.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 38
- Makes
- 0
- Views
- 218
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a drying rack that uses chopsticks that you provide to hang fresh pasta to dry. The holes are 4mm square with a slight upward tilt to make sure that chopsticks that are round or smaller than the hole can still be used. This printed really well across 4 plates in a Bambu X1C - Orca Slicer with PLA defaults, where the center post was laid flat and at a diagonal on the plate. No supports were needed for this to be successful in PLA. The tolerances are tight to prevent wabbling but still fit with just a little pressure.
This stands about 12.5 inch / 315mm tall when assembled - total width is dependent on your chopsticks.
I have included STL and 3MF (for printers that support it).
Enjoy