Noodle / Pasta rack for drying fresh pasta
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This multipart assembly uses chopsticks as bars for fresh pasta.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a drying rack that uses chopsticks that you provide to hang fresh pasta to dry. The holes are 4mm square with a slight upward tilt to make sure that chopsticks that are round or smaller than the hole can still be used. This printed really well across 4 plates in a Bambu X1C - Orca Slicer with PLA defaults, where the center post was laid flat and at a diagonal on the plate. No supports were needed for this to be successful in PLA. The tolerances are tight to prevent wabbling but still fit with just a little pressure.
This stands about 12.5 inch / 315mm tall when assembled - total width is dependent on your chopsticks.
I have included STL and 3MF (for printers that support it).
Enjoy