1 / 7
Völund Forge REMIXED "OugleSauce" - VOC, Carbon circulation filter for Creality K1/K1C/K1 Max — image 1
1 / 7

Völund Forge REMIXED "OugleSauce" - VOC, Carbon circulation filter for Creality K1/K1C/K1 Max

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Carbon internal circulation filter based on Creality K1/K1C/K1 Max useless (unless you print speedbenchies) side fan.

Rating
5 / 5
Likes
8
Downloads
66
Makes
1
Views
465
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

Remix of @Nicorn_574492 file
https://www.printables.com/model/907645-ouglesauce-voc-carbon-circulation-filter-for-creal/files

Changes based on suggestions by @tbkMAKER:

Duct: Widened the rear mounting hole. Re-sized the side mounting hole for the 'Base' to work with an M3 screw.

Base: Re-sized the side mounting hole for the 'Duct' to work with an M3 screw.

All parts: Re-sized for 1/4"x1/8" magnets so you don't have to use the crap blamazon selection. Go to McMaster Carr or whoever - I have no affiliation with anyone.

Printing

Supports required for bracket portion of “Duct” part. Other parts should be good with no supports anywhere.

BOM

- Magnets 6х3 mm - 19 pcs
- “Voron” heated inserts (M3, outer D 5, length 4) - 5 pcs
- M3х10 screws - 4 pcs
- Activated charcoal (0.5 liters approx)

Assembly

  1. Insert heated inserts (locations are marked on pictures)
  2. Install (superglueing recommended) magnets to all places for magnets you see. Remember to check for polarity!
  3. Place "Base cover" onto fan, then place “Base” onto base cover and screw everything together using M3x10 (3 screws).
  4. Install “Duct” using one stock screw and one M3x10 (to fix to “Base” part).
  5. Fill "Cartridge" with charcoal, close cover.
  6. Install assembled cartridge onto base.
  7. Profit!
  8. Optional - Between Base part and cartridge there's a provision for additional thin paper/non-woven fabric filter. If you have issues with your charcoal being too dusty - that's the fix for you.

Tested (V1 model on real life photos) and working well, no ABS smell after overnight print.

V2 (shared here) should perform about the same (it has improved looks, joints and tolerances over v1).

Please share your prints!

P.S. Purpose of such duct design - to have possibility to install Active heater for chamber at the end of it. Step is attached so feel free to design heater holder.

Tags