Liquid Draining Station
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Tired of balancing your half-empty liquid bottles upside down in a mug, only to end up with more frustration than liquid?
This clever little gadget is here to save your day – and your juice!
The Liquid Draining Station holds up to four 10 ml liquid bottles and lets you flip and drip like a pro.
Before use, remove the cap and dropper tip from the bottles. Then slide each bottle from below in the cylinders, and let gravity do its thing.
No mess, no stress – just sweet, sweet efficiency.
It fits common containers (Ø 55–65 mm) and comes in two flavors:
Stand A for containers up to 73 mm high and Stand B for up to 120 mm.
The cylinders fit bottles with a max diameter of 22 mm – standard stuff for most vapers.
Printing information
All STL files are correctly aligned.
Layer height: 0.2 mm
Perimeter: 2
Infill: 10-15% for the stand and cylinders, 100% for the rods and end caps.
Brim: Not needed – unless your rods are rebelling against the build plate.
Support: no
Assembly Instructions
Position the four cylinders as shown in the photos.
Insert a rod through each set of aligned holes and push an end cap onto the rod.
If needed, you can secure the end cap with a small drop of glue – but be careful to use very little, so the rod doesn’t stick to the stand.
I am looking forward to your Makes! :-)
If you like this design, feel free to check out my others here.