Case for the NanoVNA test fixture PCB.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple case for the test PC board. Two versions of the top, one labeled, one without depending on configuration.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 225
- Makes
- 2
- Views
- 560
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is a case for the little test board. There are two versions of the top. I configured my board with the top left connector shorted, the top right connector has a 50 ohm resistor, and the bottom two connectors are bridged. I use these for calibration of the VNA before making measurements. If your board is configured differently, there is a blank version of the case top without labels.
The case is designed for M3 x 8mm screws, however the PCB holes will have to be just slightly drilled out to allow the screws to go through.
Modeled in FreeCAD