Sudanese Mobius Band
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I remixed this from the model by stepanp21, https://www.thingiverse.com/thing:1779983. "...the Sudanese Möbius Band,…
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 69
- Makes
- 0
- Views
- 481
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution
I remixed this from the model by stepanp21, https://www.thingiverse.com/thing:1779983.
"...the Sudanese Möbius Band, where 'sudanese' refers not to the country Sudan, but to the names of two topologists, Sue Goodman and Daniel Asimov."
I smoothed it in one model and added a flat base in the other.
The area near the bottom can be difficult to print unless you use some support and fine layers. I used minimal support inside to get the crossover without sag. It can be hard to remove, so keep it as light as possible. Either that or improve your bridging settings.
I used PLA, 215/60 degrees, .2mm layers. Finer layers will look better.
The models here a little over 3 inches tall. Scale if you want them to be larger (or smaller).
Category: Math Art