DeepCool Matrexx 50 Mesh Honeycomb Front Panel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cute custom front panel for better airflow. Doesn't require any extra tools or bits bobs.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 83
- Makes
- 0
- Views
- 462
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Public Domain
Consists of 3 parts but doesn't require any tools.
To place it - Grab a panel piece by the sides, line up the long clippers with the holes in the case chassis and then push until it clicks. Then push every side until it sits properly.
To remove it - Grab a panel piece by it's sides and grab the hexagonal holes closest to your hands with your thumbs. Then wiggle and pull (the top one may take a little bit more pull strength than the lower ones).
Took me 12 hours of total printing time. Anycubic Kobra 2 Neo - 0,2 - 150mm/s - PLA. Weighs 185g.
I recommend that you make your own gcodes using the STLs. (The gcodes uploaded here are not the same ones I used. I made mine in Cura but they wouldn't upload here so I remade them in PrusaSlicer)
(In the PC photo there is a 2mm gap between the middle and top part but I fixed that in the files, don't worry)
I made this after realizing my new processor was thermal throttling at 90 degrees and removing the stock front panel entirely fixed that. Perfect opportunity to make a custom one! Right now with this panel it gets 77 degrees under full load, no throttling.