LayersFactory
Report model
1 / 3
Prusawire Rear Deck Cover Plate — image 1
1 / 3

Prusawire Rear Deck Cover Plate

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Source
Printables
Category
Prusa Parts & Upgrades
License
GNU General Public License v3.0
DetailsMakes & commentsRemixesCollectionsRelated

A rear deck cover panel to cover exposed wiring (particularly for those using the WAGO holder block) on the Prusawire 3D Printer.

NOTE this is currently designed against the Beta 1 Y-Axis parts.  These are changing in the future which may require a revision to the rear deck cover panels!

Parts

Left Side Piece:

deck_panel_rear_connector_m3_erikbuild-v20250814.stl

Has three holes for M3x10 FHCS

Connector Block:

deck_panel_rear_connector_m3_erikbuild-v20250814

Designed to accept 4x Voron Spec M3 Heat Inserts - M3x5x4

Right Side Piece - Prusa Black (Delta) PSU:

deck_panel_rear_m3_countersunk_left_deltablackpsu_erikbuild-v20250814

Requires 3x M3 - 3030 T-Nuts (see below).

Requires 6x M3x10 FHCS (see below).

Right Side Piece - Prusa Silver (Old) PSU / Meanwell LRS-350-24 / Meanwell RSP-320-24 PSU:

deck_panel_rear_m3_countersunk_right_silverpsu-meanwellpsu_erikbuild-v20250814

Requires 2x M3 - 3030 T-Nuts (see below).

Requires 5x M3x10 FHCS (see below).

This variant features a little power cable pass-through port since these power supplies route the 24V power lines out the back.  The pass-through features little slots for zip ties to secure the wiring and avoids typical placement of the WAGO connector terminal block holder.

Hardware Required

  • 9-10x M3x10 FHCS
    • depending on how many screws needed for the right side piece
  • 4x Heat Inserts M3x5x4 (Voron Spec)
  • 5-6x M3 roll-in T-Nut for 3030 Extrusion
    • Prusa sells this as M3nEs
    • I used this EXCELLENT model to print the nut and added the M3x5x4 heat inserts to them.

Print Specs

  • Voron Print Specs
    • Layer height: 0.2mm
    • Extrusion width: 0.4mm, forced
    • Infill percentage: 40%
    • Infill type: gyroid
    • Wall count: 4
    • Solid top/bottom layers: 5
    • Supports: NONE
  • I chose Prusament Galaxy Black ASA.

Change Log

v20250814-5: Improved M3 screw hole diameter and chamfer to Voron Design specs for easy installation.

v20250814-3: Fixed through-hole on the connector piece to allow M3x10 and longer screws.

v20250814-1: Initial release.

Tags

3dprintervoronswitchwireprusawire