OV3660 Camera Mount to Flashforge Adventurer 5M (AD5M)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cheap webcam implement to AD5M
- Rating
- 5 / 5
- Likes
- 48
- Downloads
- 239
- Makes
- 0
- Views
- 1,470
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- GNU General Public License v3.0
Cheap webcam implementation to AD5M
Flashforge sells camera kit, but it's kinda expensive in here, so i wanted to go to cheaper route.
You need:
- (Maybe) Klippered AD5M - Haven't tested with the original firmware so it might work or it might not. I have FORGE-X firmware on mine.
- 30x25mm Wide Angle OV3660 - Module. These are 7-8 bucks in AliExpress.
- 2x M2 screws, max 4mm long. (These are kinda optional-ish, it seems to hold without these aswell but the case was designed for these in mind.
- 1x M3 screw. I used a PSU mounting screw from a PC case.
- (Optional: 5Pin PH2.0 connector and soldering iron. These modules usually come with USB wire, but plugging it into the back of the display is much neater-looking option. )
Printing: Face down, i printed on 0.12mm layer height, haven't tested other heights. Atleast PETG, but ABS/ASA is recommended because of the heat resistance.
Install camera to the housing, attach to display, screw to housing. Add a camera in the Klipper's options (Settings → Cameras) and make sure to put resolution to either 1920x1080 or 2048x1536 to the config file or it shows just partial image. (Configuration → mod_data → camera.conf)
Depending on which way you put the module in, you might need to flip the image in the Settings.