1 / 1
3/4 PVC 90-Degree Angle Adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Uses a 3/4 PVC piece to make it a handle. Requires Wood Screws. Can be used for many things. Mostly for a Nerf Shield.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 67
- Makes
- 0
- Views
- 225
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Share Alike
It is a 90-degree adapter for ¾ PVC to convert it into a handle for a shield. It must be drilled into the bottom, where there is no hole for the ¾-inch PVC. It may need some more fine-tuning, as it may be too tight for certain PVC piping.
Requirements:
¾ PVC (1)
~2 Wood Screws (Use more if needed for more support)
Printing: Use 50% or higher, with 4-5 walls. Only tested with these settings.
Change Log: