Replacement top washer for Dudley Turbo 88 Syphon
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Top washer to restore half-flush on Dudley Turbo 88 Syphon
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 30
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Probably the simplest/easiest thing I've ever designed. But someone might find it useful!
The Dudley Turbo 88 (and similar Dudley models) allows half and full toilet flush options. It does this by using a washer arrangement that admits air into the syphon chamber when the water level drops to the top of the syphon during a flush. This stops any more water from being drawn through to the pan, and gives you the desired half-flush.
But, over time (and immersion in water), the washer eventually softens. So it stops gripping the flushing rod and, even if it lifts up correctly at first, it just slips back down the flush rod. This covers the vent hole, and you end up with a full flush that you didn't want.
Now, you can get a full official service kit from Dudley for about £8, and it's excellent value. But most of the time a new washer is all it takes to restore your half-flush.
A washer is easy enough to draw in any CAD software. But as the whole process relies on the washer gripping the shaft I added 3 small nibs to it to ensure it grips the rod and helps stop water flow drawing it back down. I dunno if that's doing anything, but I figured it couldn't hurt!
I printed the washer in TPU since it needs to be flexible enough to create a seal for when a full flush is needed.
It's there in the pictures above: It's sitting right underneath the blue disc that the yellow flush rod passes through, and you can just see it peeking out.
At the time of writing, mine's been installed for over four months and has performed faultlessly throughout.
I've provided STL, step, and 3MF files, along with the FreeCad file, to give you options, or to allow you to re-draft. My preference is for step files as they provide a proper curved edge whereas the STL uses a series of small facets instead, and these may affect fitment.
Although some might consider this design a bit of a turd, I'm flushed with success over how well it's worked!
Happy 3D flushing!