Ring Contact Sensor Gen 2 Adapter for Garage Doors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Need to put a ring contact sensor on your garage door? Use this!
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 46
- Makes
- 0
- Views
- 206
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Need a mount for your Ring branded contact sensor? Use this! The main body will slot directly into the inner portion without needing tape or other sticky substances. I mounted the back of the “inner” labeled part to my garage door with VHB tape, but anything heat resistant should do!
The outer portion will dangle down when the door has gone up enough. This will work for metal garage doors, but the magnet in the sensor will keep it attached just a little longer than if using non-magnetic surfaces. For me, I just taped this to the highest portion of the garage door so gravity would overcome the magnet pretty early in the opening cycle.
Safety note: Check placement before taping in place. If you place it to high on the door panel, the magnet will stick to the panel when the door is open and will not come back down on it's own. This could harm the door, the sensor, or even you if the plastic gets crushed and sends bits flying. Dry fit before committing to final position