DDU for Simagic Alpha Evo Pro (for an iPhone 7) - No Screws needed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is V2 of my iPhone 7 Holder which im using as an DDU, it doesnt need any screws and attaches magnetially to the WB
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 30
- Makes
- 0
- Views
- 597
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is V2 of my iPhone 7 Holder which im using as an DDU, it doesnt need any screws and attaches magnetially (with 2x12mm Neodymium Magnets) to the WB.
Features:
- No Screws needed
- Magnetic attachement
- Faceplate swappable
- Horizontal allignment with extra Pin on the back reusing Simagics Cutout
The faceplate has clips to make it easier to print and also lets you print it in a different color if wanted. Caps for the magnets arent necessary, it works without, i even left them out on my print.
Got some prior Feedback to my design and made different faceplate versions, one with the Homebutton Cutout and one Without.
##############################
Its essential that your Printer is properly calibrated in regards of print dimensions, If that isnt the case, the clips might need some adjustment and the phone will be jammed in there, not being easily removable.
To accomedate for that I put in 2 holes on the backsite near the magentics to poke them out if they need to be removed. Theres also a hole on the lower side to push the phone out if its jammed in there and i made the 2 Faceplates with slightly smaller clips as additional versions.
##############################
Print Settings
Printer Brand: Anycubic
Printer: i3 Mega S/Pro
Rafts: No
Supports: Yes
Resolution: 0.2
Infill: 15%
Notes:
Regarding Supports:
Try avoiding to put supports on the Pin cutout on the back, Ive noticed its hard to get them out, it worked, but just barely.