snot — bike wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stylish way to hang your bike on the wall
- Rating
- 0 / 5
- Likes
- 35
- Downloads
- 90
- Makes
- 0
- Views
- 840
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is inspired by a commercial product that is also 3D printed but very expensive.
This design uses a 25mm wooden rod. The main mount is made up of two pieces that need to be joined together with two dowels and a standard M3x14 cylinder screw - you can use a longer one. I did not need to use any glue, the two pieces stay together fine with the dowels and the tensioning screw.
If you want to recreate the original design, use 0 bottom shell layers and an infill that you like to produce the infill effect on the outside of the mount. I had good results that looked surprisingly close to the original with ‘Adaptive Cubic’ 25 infill % with a 45° orientation - see the attached .3mf file.
The design is parameterised in FreeCAD, you can change the values in the spreadsheet to change the tyre width, maximum wheel height (tyre + rim) and rod diameter.
I have added a few .step files as examples which are also in the 3mf file. The snot.wall-mount.v2.55w-100h.step supporting a tyre width of 55mm and a maximum height of tyre and rim of 100mm.
I printed a few of these in PLA, but any material should work as there is not much force to any part of the mount: The bike is basically standing on its own. Just be careful not to overtighten the screw that goes through the center into the wall.
Have a look at the gear storage in the same design: https://www.printables.com/model/1391937-snot-bike-gear-wall-storage