Cable Tie Organizer with Magnets
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€8.43 – €10.30 net (excluding VAT)
For file: Cable Tie Organizer with Magnets_0.8n_0.55mm_PLA_MK3S_4h29m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €9.36 excluding VAT (range midpoint).
- Weight reported by the author
- 219 g
- Print time reported by the author
- 4.48 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
It's a cable tie organizer. With magnets. That's it.
- Rating
- 0 / 5
- Likes
- 123
- Downloads
- 160
- Makes
- 0
- Views
- 1,146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
It's an organizer for your cable ties, and it's big! This is held in place with four 20mm x 2mm captive magnets, which are added during printing. Make sure to either use the attached .3mf, or to manually add appropriate “pause print” gcode instructions. This is not a remix, but was inspired by this design, which uses screws to anchor the organizer.
This was designed and sliced for a 0.8mm nozzle. You could get away with thinner walls behind the magnets with a smaller nozzle, which would improve their holding strength. Heck, you could even stick with a 0.8mm nozzle and move to a single layer behind them to improve the strength. A STEP file is attached in case you're interested in changes like this.
This holds fine attached to my toolbox, but slides right down my whiteboard. You may need bigger magnets if your surface doesn't have a lot of friction, or if it doesn't have a thick ferromagnetic surface. It is very easy to add additional magnets in PrusaSlicer, simply do the following:
- Right click on your model > Add negative volume > Gallery
- Navigate to the ‘Magnetic Insert.stl' file included with this model
- Scale the magnetic insert to match the size of your magnets. Add 1mm+ of tolerance to the X/Y/Z dimensions, no need to be stingy with tolerancing on captive parts.
- Ensure that the flat part of the negative volume is oriented up in your print (positive Z direction)
- Move the negative volume to wherever you want the magnets in your model
- Slice the model
- Scroll the the layer where your negative volume gets covered up > Right click the ‘+’ sign next to the layer scroller > “Add pause print (M601)”