T2 female thread adapter for 2” eyepiece holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
T2 (M42x0.075) female thread adapter for 2” eyepiece holder
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 90
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution — Share Alike
To print this piece, I recommend a layer height of 0.12 mm. External perimeter speed of 40mm/s.
Set the nozzle and hotbed temperature, the lowest possible that are compatible with the material you use, to reduce the shrinkage of the piece to a minimum and not lose functionality.
It is important to place the piece with the correct orientation and configure the seam at the back (see image) to match the slot. The printed thread will be completely clean.
Check my configuration file to have an orientation of the parameters that give a good result, without forgetting your experience.
Finally, I added the adapter with two heights: 16 and 20 mm. I have also left the versions with a small flange.
I have been printing these pieces with ABS, but with PETG they look great.
Have a good astronomical observations!!!