Adapter Chitu Filapartner E1 to Polydryer Box
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.30 – €2.81 net (excluding VAT)
For file: MidPart PRINT_0.4n_0.2mm_PETG_COREONE_2h5m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.56 excluding VAT (range midpoint).
- Weight reported by the author
- 45 g
- Print time reported by the author
- 2.08 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Adapter for Polydryer boxes to fit Chitu Filapartner E1 Filamentdryer
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 61
- Makes
- 1
- Views
- 906
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter makes Polydryer boxes fit the base of the Chitu systems Filapartner E1.
If you own polydryer Filament boxes you also can use them on the Chitu systems Filapartner E1 to dry filaments. Saves deskspace and some say the Chitu dryer is a bit better, because he has better ventilation and more options to dry filaments. (and you can place the polydryer a side your printer to print with ongoing drying process.
This model consists of three parts:
- Top (fits the Polydryer box)
- Midpart with air ducts
- Bottom Sits on the Chitu E1 base
(two versions:
a) for threaded heat set inserts
b) without inserts, screws directly into the plastic
All three parts are held together with countersunk 8 M3x16mm screws. You may use glue instead of screws and use the holes just to make best fit.
The adapter is designed as flat as possible and fits snugly to the Chitu E1 base. The polydryer box sits tightly and securely on the adapter and will not fall off too easy.
To print this model PETG filament is recommended, I did not test PLA because I think it may be a bit too brittle.
The model may be printed with standard settings:
0.4mm nozzle,
0,20mm layer height,
at least 2 perimeters
20% infill
no supports needed
Please show me your printing results and send me fotos of your makes. I like to see how you use this model. If you have ideas for improvement don’t hesitate to send them to me in the comments. I will try to incorporate your suggestions and will modify the model for special needs if you ask me to do so.
And of course a like ♥ or a rating ⭐ of the design are always welcome.
happy printing,
clamikra