Sunlu FilaDryer S1/+ metric version with ECAS04 Pneumatic Connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Updated for the 21st century, and those outside the USofA. Now with metric fixing hardware and ECAS04 connector.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 66
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
Thanks to ramservices for the original design.
I have redesigned for metric hardware and a better passthrough of filament. Thanks to ramservices for the original design, I have redesigned for metric hardware and a better passthrough of filament.
I have redesigned the rear conector to use captive nuts & ECAS04 Pneumatic Connector, additionally only 5 M2.5 holes need to be drilled into the clear polycarbonate top shell for 4 M2.5 X 12mm fixings and filament to pass through.
BOM
4X M2.5 X 12mm screws
4X M2.5 nuts
1X ECAS04 Pneumatic Connector - https://www.aliexpress.com/item/1005008678124178.html?spm=a2g0o.order_list.order_list_main.73.76ef1802ARcmyQ
All you will need is a drill with a 2.5mm drill bit to cut the 5 holes needed for the fixings and filament pass through.
BUILD INSTRUCTIONS
I printed the parts and run a drill through the holes in the printed parts, I then temporarily installed the internal part with a bit of double sided tape in the correct location to mark the position of the holes to be drilled.
Once all 5 holes have been marked I removed the internal section and drilled the holes through the clear polycarbonate lid. (make sure to cleam the hole in the centre for the fillament to pass through by removing any burs from the drilled hole.
now its time to install the hygrometer into the internal cradle and install the 4 M2.5 x 12mm screws ans push theassembely into the interior and through the 4 x holes you have drilled.
Take the external part and press fit the ECAS04 connector into the printed part(you may need to persuade it into its new home if your print is a bit tight)
now slide the external part onto the 4X screws and put in the nuts.
From the inside of the lid use your hex key to screw the two parts together.
Your done.