1 / 2
Whetstone Wedge
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Whetstone wedge for 25x50 cross-section whetstone.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 76
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Share Alike
Yet another wedge for whetstone but this wedge
- sits rather tight (for 25x50 cross-section whetstone) and
- can be printed without support.
Printing:
- lay flat side down
- no supports
- 3 walls (outer, inner, outer)
- 7% infill
- PLA+
Rule of Thumb:
- 10° for kitchen knife
- 20° for pocket knife
Note that the whetstone board belongs to the sink. The feet shall tightly fit the sink below dripping water, so you have all hands free for sharpening.
See also the FreeCAD project file on GitHub: wedges.FCStd.