1 / 2
Nerf Mega XL Magazine, Full Length and 70mm v2!! 5&6 Round Options — image 1
1 / 2

Nerf Mega XL Magazine, Full Length and 70mm v2!! 5&6 Round Options

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Here are my v2 Mega XL Mags made possible with the direct help of Misplaced Moose!

Rating
5 / 5
Likes
24
Downloads
86
Makes
3
Views
491
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

They are a huge improvement over the v1 Mags in every way. Huge shoutout to Misplaced Moose for making these improvements. The optimized print orientation reduces print zip and allows them to function much better than before. The base cap now locks in place with a dovetail and only requires 1 screw to hold in place. The bottom cap now has an option with air holes to increase the feed rate for my upcoming MXL flywheel blasters.
 

Print Settings 

I would recommend 3 walls, 10% gyroid with a brim for all the parts 
 

The Mag body prints on the bottom angled face
The Follower prints with the spring slot facing up
The Cap prints on the flat end, on the side with the dovetail

Hardware Required 

1 - #4 screw 

1 - Out Of Darts Drum Spring

Assembly Instructions 

The mage is assembles by inserting the drum springs flat end into the slot in the mag and pushing it down into place until it clicks in.

The thread a piece of string about 10 inches long through the drum spring and let the two leads down the mag.

Grab both ends of the string and carefully pull the spring upwards while making sure it remains flat. You will want to pull it about 2 inches past the end of the mag.

Then carefully hold the follower into position without dropping it down yet. Let the string with the spring down into the spring slot on the follower while still holding it, once in place, pull out the string and drop let the spring take the follower into the mag.

I would now recommend pushing the follower down and dropping a few drops of this silicon oil down each guide for the follower to help it work a bit better at first 

Tags