Hollowed Haunted House

If you're interested in the commercial use of my models, earlier access, exclusive designs or if you simply like my work and want to support me, please check out my Patreon at https://patreon.com/29flo and subscribe to a membership tier that suits you. 

This piece is hollow, making it possible to place a light source inside. For the photos shown here, I used a compact SmallRig LED lamp, but you can easily use any light you have on hand. Just to clarify please don’t use real candles inside :)

[ Suggested Print Setup for 25cm figurine ] - You can scale it up or down as desired.

Nozzle: 0.4mm
Layer Height: 0.24mm ( You can adjust the layer height based on how much detail you want ) 
Infill: 5%
Wall loops: 2
Supports: Tree (auto)
Printed with:
- PLA Matte Charcoal 

Printed with fuzzy skin effect:
Fuzzy Skin: Contour
Fuzzy Skin Point Distance: 0.2
Fuzzy Skin thickness: 0.2

These photos are real and show an actual 3D-printed figure photographed by me.

As always!
The key to printing my figurines is having good adhesion to the build plate. I use CryoGrip Pro Frostbite for printing, which provides excellent grip, ensuring that every figurine prints successfully every time. I mainly use filaments from Bambu and have no issues with them either. If you have a different setup, make sure to focus on build plate adhesion, use high-quality dry filament, and everything should be fine.