Nerf Rival Pilot Aluminium barrel mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Front end replacement for 16mm aluminium barrel.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 16
- Makes
- 0
- Views
- 171
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This mod allows the use of half length darts in the Nerf Rival pilot blaster. It replaces the front end with a slot for a 16mm Outer diameter barrel. Tested and works great, unfortunately i dont have a chronograph but i believe similar setups shoot 150 fps with a printed barrel, so the aluminium barrel should be a little better.
The fit should be fairly snug but may require some glue or clear tape to secure the barrel. You can print however you like but i recommend a strong setup.
After some testing i believe optimal barrel length is around 10cm, the one pictured is 18cm and had poor accuracy. Changing to 10 was a significant improvement. Unfortunately this means a scar wont fit without modification to the design.
Print settings i used for ender 3 v1 (PLA+):
6 layer top/bottom
4 layer walls
cubic infill 20%