Speaker Pivot Wall Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made a Remix of the Speaker Pivot Mount to install on a wall without the lose of degrees of freedom.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 46
- Makes
- 1
- Views
- 186
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bill of material for one mount:
- 4 x M5 nut
- 1 x M4 nut
- 1 x M5x14
- 2 x M5x12
- 1 x M4x14
- 1 x M5x35
Install process:
Insert a M5 nut into the Base.
Insert the M5x14 into the Base pivot and screw it into the base
Insert two M5 nuts into the Up-Down Pivot, this is difficult because of the small amount of room. I recommend screwing a M5 bolt thru the part and than holding the nut in front of the bolt with tweezers. when the nut is on the bolt, you can screw the nut back until it is in the part.
Secure the Up-Down pivot into the Base pivot with two M5x12.
Insert a M4 nut and the M4x14 nut into the Left-Right Pivot.
Secure the Left-Right Pivot into the Up-Down Pivot with a M5x35 and a M5 nut.
You van now loosen the Base and you will notice the the bolt can not be taken out of the mount.
