Stick-on play kitchen: Stovetop

Simple “stick-on” play stovetop. Simply add to any table surface, loose plank, place-mat, cutting board etc. with double-sided tape. Easy way to furnish a DIY play kitchen, or to create a full play kitchen experience that can neatly be stored away when not in use, or even taken on the go. For example stick it on a ~30x35cm plank and it fits nicely down into an IKEA Kallax drawer alongside all the pots and utensils.

Options:

Choose between gas or electric hobs, an induction/ceramic stovetop, and between 1, 2 or 4 knob mounts. 

The hobs are by default ~80mm in diameter. Scale them according to your play-set pots and pans.

Printing:

Everything is printable without support, except a tiny bit under the tabs on the knob-mounts(the installed knob will hide all blemishes from the support). 

I strongly recommend PETG for the mounts and using the "TighterTolerance" versions. If you are attempting to print them in PLA, I recommend the regular version with 100% infill and/or 3-4 perimeters. The PLA tabs will likely permanently bend a bit(if not break off entirely) when assembling, so there will be more slop in the indexing of the knob. 

I recommend you print a knob and single mount first to test your fit/tolerances and material.

Assembly: 

I recommend putting a small drop of a non-toxic grease inside the knob before assembly. Especially PLA against PLA will have a lot of friction.

The knobs are designed to permanently fit on to prevent the exposure of any small or sharp bits. So make sure you are properly prepared before pressing them on.

More:

Get the matching “stick-on” sink here: https://www.printables.com/model/1419444-stick-on-play-kitchen-sink 

Or toaster oven: https://www.printables.com/model/1421036-play-kitchen-toaster-oven 

Or see the collection of other compatible play kitchen accessories: https://www.printables.com/@rhn_3626299/collections/2665113