Flexible cell interconnect press form, h=47mm, strip h=4 w≤60; for Rept CB75
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The press form is intended for pressing a 47 mm height expansion curve into 212 mm long metal strip material.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 6
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print was made with PLA and 15% gyroid infill. That is not strong enough to press the form in 4 times 1 mm aluminium, EN-AW1050 soft tempered, strips. I press between two 10 mm thick steel splints. Initial pressing is done with glue clamps because my vise is not wide enough. After the glue clamp compression is enough I switch over to the vise as pressing with the vice requires considerably less force. After the shape comes out of the form, it is not completely flat. Some hand bending as applied to flatten the “feet”.
I prefer the flex of this 47 mm expansion curve over the 25 mm of my other CB75 press form model.
These models are made using Erwin Rieger's OpenSCAD pressform busbar parametric model.