1 / 2
HF Hydro-Force SUP Board Fin
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement fin for an HF stand up paddle board.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 259
- Makes
- 0
- Views
- 453
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement fin for an HF stand up paddle board. The fin geometry isn't a perfect replica but should work well enough, and the locking mechanism is tested and works. The part prints fairly well without supports, but would benefit from a small support on the center rib between the two finger tabs. Make sure the model is set fully on it's base, as the bottom is sloped slightly.