1 / 8
Safety Collector for Snap-Off Blades - with FreeCAD design — image 1
1 / 8

Safety Collector for Snap-Off Blades - with FreeCAD design

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Safety collector for common snap-off blades and razor blades.

Rating
5 / 5
Likes
10
Downloads
44
Makes
1
Views
183
Reviews
1

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

This is a safety collector for snap-off blades. 

To use it move the blade so that the line you want to snap aligns with the outlet of the handle (see picture left). 

Then insert the blade into the upper lip of the bottle up to the same line (picture right) and break it by tilting the knife. As long as no part of the blade is fully exposed this should be safe and no shards can fly off.

The bottle collects the shards. The internal part of the lip will prevent the shards from falling back out.

It is possible to open the container and remove the shards. However, it is recommended to leave it closed: put a piece of tape over the lip, and toss it in the trash. Simply print a new one for the next batch of shards.

If your work environment has increased safety requirements (or there are children about), put a drop of glue on the screw thread of the lid before screwing it in - that way it will be impossible to open the bottle and expose the shards.

Printing

This can be printed in PLA or pretty much any other material. The GCode in this project is for PLA on the Prusa MK4S. The collector.3mf file contains the corresponding PrusaSlicer project with all the correct settings.

Print the lid with its rim down and the screw thread up. Usually no supports are needed - the overhangs are short enough. No special infill is needed, out of an abundance of caution the default GCode was generated with 25% cubic infill for added torsion resistance.

Print the bottle standing up (big opening down). If you use a patterned print sheet I would recommend a brim for better adhesion. The critical part is the lip on top - increase the number of perimeters (for a 0.4mm nozzle at least 4 perimeters) and set infill to 100%. The slicer might complain about the overhang in the middle of the underside of the lip - you can ignore this, it is not critical.

Tags