Pwnagotchi Slim (Slimagotchi) + waveshare + ups lite
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.96 – €1.17 net (excluding VAT)
For file: slimagotchi_upslite_case_0.4n_0.2mm_PLA_COREONE_50m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.06 excluding VAT (range midpoint).
- Weight reported by the author
- 18 g
- Print time reported by the author
- 50.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Remixed to allow using the original ups lite spacers and screws
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 76
- Makes
- 0
- Views
- 536
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Original model requires shorter spacers for the ups lite battery pack.
In my pwnagotchi I am unable to install the shorter spacers as it causes the pi board to press on the battery and is very dangerous. There is heat etc. and the battery needs some free space (see galaxy note 7 fiasco).
I remixed it to add grooves on the wall to allow the screw heads to slide instead of squeezing the battery, so it fits in the same external dimensions.
Also scaled it a bit to fit the entire pwnagotchi slim well.
Tested hardware: Raspberry pi zero 2 w + Waveshare 2.13 V2 + UPS Lite 1.2
Update: Added a small groove for camera connector which was really tight in the previous version