Völund Forge REMIXED: K1 aftermarket SSR mount - big heatsink
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed version of KrzysztofGW's SSR v2 mount to accommodate the large SSR heatsink sold on Amazon.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 14
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed version of KrzysztofGW's SSR v2 mount to accommodate the large HS-100A SSR heatsink sold on Amazon. It’s probably overkill but the SSR shouldn’t overheat™. the overall height of the heatsink will require modification of the bottom plate, a protective cover for the exposed SSR connections (if your SSR does not already have one), and any feet that raise the bottom of the printer for clearance as a good measure. You will also need to clearance some of the plastic ribbing below the plate for it to seat correctly. This is easily accomplished with the nippers supplied with your printer and a pair of pliers. If you’re bugged by the appearance after, a plastic smoothing tool will take care of any unsightly bits.
Don't forget to use a small amount of thermal paste between the SSR and the heatsink.
HS-100A Heatsink (unaffiliated) - https://a.co/d/dAG9tWv
Please note: After I printed the previous iteration of this plate I found the power supply standoff was in the way. I clearanced the plate for the power supply standoff manually with a 6mm drill bit and a deburring tool. The clearance cutout was then added in fusion but not tested. I made it considerably larger to ensure it would clear once printed.
Also, the lengthened portion is unsupported and can potentially cause a vibration/rattle. I do not foresee this being an issue overall, but a strip of foam window insulation tape will reduce the chances for these potential issues to cause a problem.
If there are issues I will make adjustments needed but I’m confident there shouldn’t be any. I‘ve included the STEP file as well.
Original model description:
4x M4S (l=4mm) heated inserts needed
The input is quite easy - BED connector:
1st pin = “red” labeled - unused
2nd pin = “+” positive
3rd pin = “-” negative
4th pin - unused
If you want higher insulation between spots - go up as there is no more space below the plate (around the inserts).