Vision Master E-213 Enclosure- The Pod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tray style pod with modules in the nose, GT-U7 gps, 3000 mah battery, bme 280, with canned message capabilities, vibra
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 0
- Views
- 108
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
”The Pod”
Here is an enclosure for the E213 LoRa device by Vision Master . Install the buttons then connect the Lora antenna, then slide the 213 board into the enclosure, slide the gps in using the two small rails positioned anove the battery , connect the cables for the environment sensor and gps to radio, slide battery in and connect, put the modules into the nose with antenna and insert, the “ open “ side of the antenna housing faces opposite direction of the screen . Use 40mm flathead m3 screw.
It prepping the wires to extend from the main body and shorten as needed for modules in the pod. Use a 40mm M3 Flathead screw with heat insert. I have assembled without heat insert and it was tight but this will depend on your prin/settings/filament. Hold the nose centered in place as you tight to maintain its position.* The open side of the screw hole on the pod attachment faces up same direction as the screen where the opening in the antenna shroud face away from the screen*
Qwik connect gps - Tx to Rx , Rx to Tx , Grnd to Grnd , 3v to 3v ; on the app set TX to 44 and Rx to 43 and enable on app.
The environment sensor attaches Gnd>grnd , vin >3v, sda>sda , scl >scl using the qwik connect. Enable telemetry on the app.