DaVinci Open Back Project
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wanted to reclaim the open space in the back of my DaVinci. Came up with this. Spool holder should fit spools up to…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 261
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted to reclaim the open space in the back of my DaVinci. Came up with this.
Spool holder should fit spools up to 95mm wide. I may upload a shorter spool holder for people who don't use wide spools and don't want anything protruding out the back.
I would recommend printing at a 70% or higher infill so the parts are sturdy.
Can probably be printed without supports, but comes out cleaner with them.
Also, spool holder requires a single 608 bearing.
EDIT: After testing this with a full roll, it looks like the bearing allows too much movement and become unraveled. Eventually I'll redesign the spool holder to not move. For now, I just pushed it against a wall to stop it rotating.
Edit2: My spool holder failed after supporting a few heavy full rolls. I tweaked the design to use an 8mm-1.25 x 70mm bolt. Had it laying around from a hobbed bolt I never built. This new design can be printed flat.
Category: 3D Printer Parts