1 / 5
Raspberry Pi 4B Case with HQ-Camera
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for Raspberry Pi 4B, HQ-Camera and 30x30mm Fan with on/off-switch
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 37
- Makes
- 0
- Views
- 227
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A solid case for a Raspberry Pi 4B, a Raspberry Pi HQ Camera and a 30x30x<10 (LxWxH) fan.
You may install a on/off-switch on one side of the case to safely shut down and boot up your Raspberry Pi. The assembled case is ready for being install on a tripod with the thread of the HQ-Camera. The GPIO pins can be routed out of the case using a ribbon cable. All other connections (USB, HDMI, Power, Audio Ports) can be freely accessed from the outside.
What you need (also see picture 2):
- Raspberry Pi 4B or Raspberry Pi with same dimensions and screw holes
- Raspberry Pi HQ-Camera
- Raspberry Pi HQ-Camera Objective
- Raspberry Pi Camera Cable
- 7x M2-M3 Screws (I tested it with M2.5 screws but i am sure it also works with M2 and M3 screws)
- 7x M2-M3 Nuts
- 30x30x<10 (LxWxH) Fan with Screws (I used four M2.5 screws that came with the fan)
- Small 6x6mm Button as an on/off-Switch
- The Printed Parts
Check out my other models too! Thanks for your support!