Tombstone Stakes Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I went through repairing our tombstones and decided I needed a better solution for staking them down
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Standard Digital File License
The tombstones for Halloween have gotten cheaper and thinner. I went through repairing our tombstones and decided I needed a better solution for the stakes that would make the tombstones last longer and be secure. Especially since we add paint and EL wire to our tombstones. These use a compliant hole to adapt to the rod sizes. This also gives some flex for wind and such.
Printing: I used PETG for the sun/weather and Extra Rough Draft since they are functional only :)
Usage: I use 2 per stake. Smaller tombstones I only used one stake and larger tombstones I used 2 (4 holders).
Stakes: I made this to adapt to 6mm-8mm rods. I buy the steel rods from the big box store and then cut them down to size.
Attaching: There is a glue channel on the back and I attached them with hot glue to the back and they have not come off. If you have problems you may want to switch to a good adhesive glue stick and/or high-temp.