4x 80mm Fan Bracket for 160mm AIO
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quad fan bracket designed for an Asetek C6J 160mm (Dual 80mm) AIO without fan mounting.There are a few quirks:Long fan…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 5
- Makes
- 0
- Views
- 71
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Quad fan bracket designed for an Asetek C6J 160mm (Dual 80mm) AIO without fan mounting.
There are a few quirks:
- Long fan screws are recommended to hold this all together.
- Long screws must not be fully set until the shroud is full installed on the radiator. (Screws fit just past the lip, holding the radiator and shroud together)
- Printed part is VERY THIN and brittle, be careful taking off supports as to not break it.
Printing Settings (On my BambuLab P1P):
- Generic PLA + standard settings (I use a low power 13600T processor (Generally in 25-35°C range even under load), if expected to run hotter, use ABS/ASA for higher temp resistance)
- For best results print at 0.08mm layer height
- Supports:
- Enabled
- 45° overhang recommended
- Tree supports not recommended (Use full standard supports)
- Part is THIN, BE CAREFUL REMOVING SUPPORTS! Recommended to use angle snips to cut off supports.
Want to buy the AIO as well? I don't sell them, but you can get them REALLY cheap on Ebay. See link below, I will not be updating the link. https://www.ebay.com/itm/283850048518
How I Designed This
Reasons
Moving into a bigger 4u case from a 2u case for my homelab prompted me to have to design this bracket, so I could mount the fans and AIO above the motherboard for exhaust.
Category: Computer