4x 80mm Fan Bracket for 160mm AIO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quad fan bracket designed for an Asetek C6J 160mm (Dual 80mm) AIO without fan mounting.There are a few quirks:Long fan…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Quad fan bracket designed for an Asetek C6J 160mm (Dual 80mm) AIO without fan mounting.
There are a few quirks:
- Long fan screws are recommended to hold this all together.
- Long screws must not be fully set until the shroud is full installed on the radiator. (Screws fit just past the lip, holding the radiator and shroud together)
- Printed part is VERY THIN and brittle, be careful taking off supports as to not break it.
Printing Settings (On my BambuLab P1P):
- Generic PLA + standard settings (I use a low power 13600T processor (Generally in 25-35°C range even under load), if expected to run hotter, use ABS/ASA for higher temp resistance)
- For best results print at 0.08mm layer height
- Supports:
- Enabled
- 45° overhang recommended
- Tree supports not recommended (Use full standard supports)
- Part is THIN, BE CAREFUL REMOVING SUPPORTS! Recommended to use angle snips to cut off supports.
Want to buy the AIO as well? I don't sell them, but you can get them REALLY cheap on Ebay. See link below, I will not be updating the link. https://www.ebay.com/itm/283850048518
How I Designed This
Reasons
Moving into a bigger 4u case from a 2u case for my homelab prompted me to have to design this bracket, so I could mount the fans and AIO above the motherboard for exhaust.
Category: Computer