Tormach TTS tool tightener
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Tormach tool tightening system that mounts to the table. It uses 2 one way needle bearings, one to tighten…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 18
- Makes
- 0
- Views
- 326
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a Tormach tool tightening system that mounts to the table. It uses 2 one way needle bearings, one to tighten and one to loosen the collet nut. This is not really a 3D printed project except for the bearing cover. The Fusion360 link is provided to do the machining of the base.
It's on a 3 x 4 x .75 inch piece of Aluminum. I spotted and drilled 4ea 1/2 inch holes and then bored the bearing holes to .998 inches. I just step up the bore offset until I got the
press fit I needed. If you've got a reamer it be quicker.
Make sure you have one bearing opposite the other before pressing them both in. I got the bearings off ebay for about $7 dollars a piece. The one I used on the drawing is pretty pricy.
Mounts with 2ea. 1/2 inch 1.5 botts to t-nuts.
Fusion 360 LInk https://a360.co/2TkrfWi
Hope it's usefull to someone.
Cheers
Kisssys
Category: Machine Tools