1 / 5
Mount for Mellow Fly SHT36 V3 on gantry/toolhead of Geeetech A30 (non-Pro, -M, -T) — image 1
1 / 5

Mount for Mellow Fly SHT36 V3 on gantry/toolhead of Geeetech A30 (non-Pro, -M, -T)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use the .3mf files, not the STL, the STL might not have the necessary cutouts and holes!! I replaced the original…

Rating
0 / 5
Likes
0
Downloads
3
Makes
0
Views
122
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike
  • Use the .3mf files, not the STL, the STL might not have the necessary cutouts and holes!!

I replaced the original GTM32 Pro VD board of my (very old) Geeetech A30 with a Mellow Fly DP5 board and replaced the old toolhead connection PCB with a Mellow Fly SHT36 V3 CANbus board, which makes wiring much easier, especially when converting to direct drive at the same time.

Everything on the toolhead is connected to the SHT (heater, thermistor (PT1000), ABL probe (a BTT EDDY DUO in this case), filament sensor (Mellow Fly MDM, runount and encoder), extruder stepper, heatsink fan, part fans, stepper motor fan) - and only one CAN cable ("XT30(2+2)") (2 wire pairs) to the mainboard (24V +/-, CAN-L, CAN-H signal).

This is a simple adapter that makes the SHT board fit in onto the place where the old Geeetech distribution PCB was located before. For good measure, I added a table management tower, taken from https://www.printables.com/model/312866-btt-ebb42-toolboard-bondtech-lgx-lightweight-direc

The SHT board fits on 2 sockets for M3 heat inserts, use M3x4x5mm heat inserts (M3x4.6x... or wider will not fit the sockets), the adapter is screwed onto the 2 metal posts on the back of the gantry using the original M2.5 (??) screws.

2026-01-04
Added version 3:
 

  • moved the cablle management to the right side to give better clearance from the left frame when homing x

  • more clearance on the left side for the housing of the x-endstop

  • moved the upper part of the plate forward for better balance

  • turned the cable management tower 90° forward in order to loose less build space in z

  • thickend the plate from 2 to 4 mm for better durability

Print Settings

Printer Brand:

Tronxy

Printer: 

Tronxy X5SA Pro, heavily modified and running Klipper

Rafts: 

No

Supports: 

Yes

Resolution: 

0.28 layer height / 125% layer width

Infill: 

15% adaptive cubic

Filament Material: 

PETG

 

How I Designed This

I just used generic shapes/parts in OrcaSlicer to put this together and added a cut-off part (cable management tower) from https://www.printables.com/model/312866-btt-ebb42-toolboard-bondtech-lgx-lightweight-direc

Category: 3D Printer Parts

Tags