Inateck FD2002 docking station drive/dust cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dust/drive cover for the Inateck FD2002 docking station, fitting 2x3.5in drives. Will fit other docking stations…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 25
- Makes
- 0
- Views
- 273
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Dust/drive cover for the Inateck FD2002 docking station, fitting 2x3.5in drives.
Will fit other docking stations having a slot-to-slot distance of 41mm (+/-0.5mm tolerated), drive protrusion of 10-11cm (some models from sharkoon seem similar enough).
The cover is convection cooled. HDD temperature increases by ~1.5C compared to open-air during operation. Internal fins slide over and stabilize the drives. The top cap is printed separately and is clip-on.
Printing tips
Optimized for a 0.4 nozzle, 0.2 layer height.
Print upside-down, as given. No supports required.
Use PLA if inexperienced. The main body may warp due to chimney effect with other materials. If that happens:
- print enclosed if possible
- lower bed temperature or turn it off completely (substitute with gluestick)
- reduce print speed above 30mm in height
Category: Computer