Inateck FD2002 docking station drive/dust cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dust/drive cover for the Inateck FD2002 docking station, fitting 2x3.5in drives. Will fit other docking stations…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dust/drive cover for the Inateck FD2002 docking station, fitting 2x3.5in drives.
Will fit other docking stations having a slot-to-slot distance of 41mm (+/-0.5mm tolerated), drive protrusion of 10-11cm (some models from sharkoon seem similar enough).
The cover is convection cooled. HDD temperature increases by ~1.5C compared to open-air during operation. Internal fins slide over and stabilize the drives. The top cap is printed separately and is clip-on.
Printing tips
Optimized for a 0.4 nozzle, 0.2 layer height.
Print upside-down, as given. No supports required.
Use PLA if inexperienced. The main body may warp due to chimney effect with other materials. If that happens:
- print enclosed if possible
- lower bed temperature or turn it off completely (substitute with gluestick)
- reduce print speed above 30mm in height
Category: Computer