1 / 4
Wio Tracker L1 case for wide 3000mah battery 755060 size — image 1
1 / 4

Wio Tracker L1 case for wide 3000mah battery 755060 size

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Case that fits the wide 755060 size 3000mah battery from the Meshnology kit. I also modified the joystick to fit better.

Rating
5 / 5
Likes
12
Downloads
69
Makes
2
Views
1,014
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Rotate models to point upwards. Case back should be on the bed, Front of case should face up. Use supports for the front of the case

I used organic supports on the case back to support the overhangs on the outside of the case, as well as the board mounting spots on the inside. Once the battery was installed, I packed the area above it with blu tack to prevent the battery from moving. 

Other Parts: 4x M2x10 screws, blu-tack or similar putty to fill space

Assembly

  1. Insert battery, with connector in lower left side of case. Angle battery so that the side that will be at the antenna side is touching the back of the case. Slide forward, then drop battery down
  2. Use blu-tack, foam, or something similar to hold battery in place
  3. Install antenna and GPS. All washers for antenna should be outside of the case
  4. Connect battery, then antenna, then GPS to the board. Install the side switch and button, then place board in the case
  5. I added two layers of electrical tape to the center of the board to help hold the board in place once the front is installed
  6. Install front joystick and button, then screw down front of case

Tags