Elegoo 550 x 650 x 750 mm enclosure extension for 4 Plus
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The factory Elegoo enclosure barely fits 4 Plus, supporting the rear wall so that the platform does not collide with it.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 53
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
The factory 550 x 650 x 750 mm Elegoo enclosure barely fits the 4 Plus printer; this part supports the rear wall so that the platform does not collide with it.
Recommended settings:
- Material: PLA or PLA+
- Wall thickness: 4 layers
- Fill: Gyroid 20%
- Bottom layer: 6
- Top layer: 6
- Support only under the protruding connector, not under the inner hexagon! Threshold angle 35° is okay!
- The printing speed can be faster, 100mm/s
Print both parts and stick them together, then use them to prop up the back side, approximately 1 cm above the platform. The printed piece fits onto the rods of the enclosure's fiberglass frame. See the picture.
They are quite large pieces, so they don't fit on every platform, but they do fit on the Elegoo Neptune 4 Plus platform.