Jaws for 2 axis woodturning (3cm, 4cm and 5cm diameter)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounting of workpieces for two-axis turning: Three jaws for use in woodturning chucks like NOVA, RECORD POWER...
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 36
- Makes
- 0
- Views
- 181
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
I try to make little wooden spoons
You first have to turn something akin to a babies rattle and then mount that ball on a different axis. I found Alan Strattons design (https://www.printables.com/model/904340-woodturning-bushing-to-make-scoops) but broke every single one…
What will it do?
With these jaws you can mount balls of 3cm, 4cm and 5cm diameter. They can be clamped strongly in the chuck. You can add additional holding pressure with tightening of the M3 screws. The slits in the sides allow access for depth measuring during hollowing.
In case of a loose fit: just clamp some paper towel with the blank. This is especially smart when you already put a nice finish on.
Versions
This is work in progress:
Version 2 features a size tag and broader slits to accomodate smaller objects through clamping.
I used PCCF, but PLA will probably work as well. 3 perimeters, 30% infill.
Hardware
2x M3 nuts
2x 18mm M3 screws
This is wholly unprofessional! Be advised to act careful around turning thingies.